However if they attempt to ping an IP on a different subnet, it won't work unless the default gateway is setup on the router and some form of routing (static/dynamic) is setup on the router. My only reason of wanting it on the main network is we have a fair bit of home automation and it would be great to get the cameras on it but this would require everything being on the same network. The PC's in the other subnet should be able to communicate with each other. It would be via a vlan either way from the Draytek. I suppose the real question here is not about switch but whether I should be looking at having the cameras + NVR on a sep subnet or not. This would mean my 16 port would be maxed outģa: This could be same subnet or different subnet to rest of the network. Cameras go onto the 24 port with the scope of internal cameras also going on there. Cameras get set to another subnet, add to the 8 portģ. Cameras set to same IP as network (1.x range) and add them the 8 port switch. This is where I would like some ideas or assistance in decidingġ. The idea is not to increase external cameras as 8 is more than enough but may add a couple inside on POE (Hikvision Cubes)īoth switches go to a Draytek router which runs over FTTP.Ĭurrently the 24 port is in-use as I have around 16 devices already on cable leaving 8 free. Everything seems to be working good, except I ran into one issue: RTSP is only accessible from the same network subnet that the camera is currently on. I have a Netgear POE switch 8xpoe, 8x normal (JGS516PE) I could use or a 24 port (GS728TP). I recently purchased two Wyze cams to investigate the potential of them being a low-cost addition to my existing RTSP camera infrastructure. Yesterday I replaced by dying RG59+2 setup of 8 cams and a Hikvision DVR with a DS-7616NI-I2 (Non-POE) NVR and a range of Hikvision cameras (again 8 in total).Įverything is up and ready to be connected to a network. Method 2: In this method you need to SSH on to each access point and statically point the AP at the controller. Yes, each VLAN is able to ping the gateway of the.
#Scw networker pro camera in another subnet Pc
Ping from PC on IoT network to Camera on IoT network: successful. Ping from PC on main network to Camera on IoT Network: unsuccessful. It all works 100 fine if I join my PC to the same subnet as the IoT devices. As per the network diagram, we’ll be putting in 192.168.10.2. And it's not just ICMP, but also http/https access to my cameras and NAS drive. Been lurking on this forum for months just taking in all the information but now I finally have a query regarding subnets. For the name, enter in unifi without the quotes, and for the IP address, put the address of your UniFi server.
0 kommentar(er)
